Make:
Ford
Model:
Mustang
Year:
1965
Mileage:
54540
Miles
Condition:
Used
Country:
United States
Region:
Nevada
City:
Las Vegas
Zip:
89101
All engine valves adjusted and stem seals checked
- Manual oil pressure test and compression test performed
Further restoration and repairs carried out by Just Peachey Classic Auto Works, East Austin:
- Rebuilt steering and front suspension components with hi-performance parts
- Replaced rear suspension components
- Replaced steering assist drag link and associated hoses
- Replaced power steering pump, flushed and bled system
A/C system:
- R134a conversion carried out.
- Pulled under dash unit to check service for cause of shorting in a/c blower.
- Replaced blower switch and blower motor.
- Pulled lower apron on front to replace dryer
- Pulled compressor to drain old oil flushed condenser and evaporator core
- Replaced leaking discharge hose and high pressure side service fitting
Tuning work completed:
- Pulled carb and disassembled to inspect
- Reset float levels back to manufacturers specs
- Ran compression check (good at 150psi)
- Installed new spark plugs and wires
- Checked ignition timing
- Installed new Power Steering Pump and Hoses
- Installed New Starter Motor
- Installed New (Yellow Top) Battery
- SunTek CXP Window Film installed all round
- New Stereo fitted: Polk Audio Speakers & Bluetooth Amp
Trunk area is clean, no rust, good spare tire and tools.
- Manual oil pressure test and compression test performed
Further restoration and repairs carried out by Just Peachey Classic Auto Works, East Austin:
- Rebuilt steering and front suspension components with hi-performance parts
- Replaced rear suspension components
- Replaced steering assist drag link and associated hoses
- Replaced power steering pump, flushed and bled system
A/C system:
- R134a conversion carried out.
- Pulled under dash unit to check service for cause of shorting in a/c blower.
- Replaced blower switch and blower motor.
- Pulled lower apron on front to replace dryer
- Pulled compressor to drain old oil flushed condenser and evaporator core
- Replaced leaking discharge hose and high pressure side service fitting
Tuning work completed:
- Pulled carb and disassembled to inspect
- Reset float levels back to manufacturers specs
- Ran compression check (good at 150psi)
- Installed new spark plugs and wires
- Checked ignition timing
- Installed new Power Steering Pump and Hoses
- Installed New Starter Motor
- Installed New (Yellow Top) Battery
- SunTek CXP Window Film installed all round
- New Stereo fitted: Polk Audio Speakers & Bluetooth Amp
Trunk area is clean, no rust, good spare tire and tools.